top of page

CABLE ANCHOR GROUT

M AND J SUPAGrout.JPG

FAST SETTING GROUT

SUPAGROUT AND RSS GROUT

SUPAgrout – is a mixture of Calcium Aluminates, masonry cement, Pozzolanic fillers, slagment, graded sands and extenders designed for cables and long anchors. It is supplied in 10 or 20kg plastic lined paper bags. Palletized or in bulk bags containing 25 x 20kg bags or 50 x 10kg bags.


RSS Grout – is a cementitious Tendon grout mixture, 8/24 High Alumina Thixotropic, is non-shrink and designed for cables and long anchors. A selection of chemicals ensures that this product, if mixed correctly, is highly pumpable in all conditions. It is supplied in 10kg woven polypropylene bags with a waterproof inner liner. Palletized or in bulk bags containing 50 x 10kg bags

Grout Properties_edited.jpg

MEDIUM SETTING GROUT

M AND J SUPER GROUT

Description
Super Grout has specifically been designed for anchoring of roof bolts. The product is highly pumpable and contains expansion agents to prevent shrinkage while the product hardens. The high ph. level prevents the corrosion of steel and cable anchors

​

Principal uses

  • Full column grouting of mechanical long anchors

  • Starter bars, cables and anchor bars

  • Void filling in concrete

  • Tunnel applications


Advantages

  • Does not shrink

  • Adjustable consistency (thixotropic or flowable)

  • Zero bleed water

  • High bond strength to steel and concrete

  • Long pot life 3 hours


Workability
The product must be mixed with a suitable pump until desired consistency is achieved


Limitations
Please note that strengths depends on the water to powder ratio, less water will give higher strengths. Grout cannot be reworked by later addition of water


Optimal water powder ratio
20kg 8lt yield 15lt
10kg 4lt yield 7,5lt


Packaging
Super grout is available in 10kg or 20kg plastic lined polypropylene bags


Mixing instructions
Pre wet mixer, add required amount of water, start to mix and slowly add grout to the mixer, depending on the consistency required. Ensure no lumping occurs. Once desired consistency is achieved pump grout into hole. Ensure proper rinsing of the mixer and tools after use


Shelf Life & Storage

12 months when stored in a cool dry place, failure to comply with these recommendations will result in a reduction in shelf life


Safety & handling
Super Grout is non-toxic, but is alkaline in nature The following PPE needs to be worn when working with the product

  • Gloves

  • Overalls

  • Protective eye wear

  • Dust mask

Accidental contact with skin or eyes must be washed immediately with clean water

MK3 grout pump.JPG

GROUT PUMPS

COMBO 2000, MK1 AND MK2

The Combo 2000, MK 1 and MK 3 Grout Pumps have been designed to be robust, user friendly, easily maintained and cost effective grout pumps.
They are capable of pumping fluids of varying viscosities including water and thixotropic grouts.

COMBO 2000

The Orica unique Pre-Stress Combo 2000 Pump comprises an air operated pre-stress pump combination. This unit is incorporated with a light weight mixing bowl made out of nylon with a steel scroll and mounting frame. The pump is very easily dismantled for ease of transport in difficult working places underground.

​

Specifications

Material: Nylon/HDPE

Capacity: 56 litres

Height: 82cm

Weight: 30.4 Kg

Safety: Not a pressure vessel

AirPump.jpg

MK3

The unique Orica MK3 nylon hand operated pump.
This pump will pump all forms of liquid and pumpable grouts and incorporates a light weight mixing tank and delivery assembly. This unit is very easily dismantled for ease of transport in difficult working places underground.
This pump is recommended where more than 20kg of grout is to be mixed at any one time. The pump is equipped with a measuring flask. The recommended maximum mix is 40kg of cable grout.

​

Specifications

Material: Nylon/HDPE

Capacity: 56 litres

Height: 82cm

Weight: 30.4kg

Safety: Not a pressure vessel

Specifications.jpg

MK2

The unique nylon MK2 grout pump is a hand operated pump that incorporates a light weight mixing tank and delivery assembly.

This unit is very easily dismantled for ease of transport in difficult working places underground. This unit features a water level mark on 4 or 8 litre capacities. This pump is recommended for a 10kg or 20kg bag of grout mixture.


Typical Application

In all stoping and development operations, the pump can be used for either primary or secondary support applications.

By simply changing the lances, grout with different viscosities can be pumped.

​

Specifications

Material: Nylon/HDPE

Capacity: 4 or 8 litres

Height: 82cm

Weight: 19.4kg

Safety: Not a presure vessel

Specifications2.jpg
bottom of page